Tired of ads? Remove them as a Premium Member. Read more
Mar 13
2015 Dodge Durango
To reset the 2015 Dodge Durango oil light, please follow these instructions:
1. Turn the ignition to run (one position before starting
engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.
Tired of ads? Remove them as a Premium Member. Read more
Oct 07
2016 Dodge Durango
To reset the 2016 Dodge Durango oil life after an oil change, please follow these instructions:
1. Turn the ignition to run (one position before starting engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.
Joined
Dec 11, 2014 · 31 Posts
Discussion Starter · #1 ·
Aug 21, 2015 Just got my 30K service done on my 14 Durango. Shouldn't this be reset? Now I'm worried it wasn't done. Sent from my SAMSUNG-SM-G920A using Tapatalk
· tomk
Joined Jun 16, 2004
·
13,121 Posts
I feel your pain, the f'knuts at my dealer didn't reset it the last time I let them change my oil. in my case I could tell by the filter that they actually did it, but I'd go back and say "do it again, and this time I'll watch. I have no way to know that you actually did it." If they didn't do all the steps, they effectively didn't do any of
the steps. They need to do it again. And maybe they'll learn something. Yeah, I'm a dreamer.
Joined Jan 18, 2014
·
77 Posts
The owner's manual has the wrong procedure to reset the oil percentage readout. Set the ignition to ON, but do not start the car. Pump the gas pedal three times, then start the engine. The usage will reset. Is the oil clean? If so, it was changed. If not, I'd doubt it.
Joined Sep 8, 2014
·
529 Posts
The owner's manual has the wrong procedure to reset the oil percentage readout. Set the ignition to ON, but do not start the car. Pump the gas pedal three times, then start the engine. The usage will reset. Is the oil clean? If so, it was changed. If not, I'd doubt it. i follow the steps in the manual
i happen to have and it works- manual is marked "fourth edition rev 1" on back and it says: Vehicles Equipped With Keyless Enter-N-Go™ last step slightly different- not sure if it matters... (could also be i just started it on last step and didnt realize....)
1. Without pressing the brake pedal, press the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (do not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pressing the brake pedal, press the ENGINE
START/STOP button once to return
the ignition to the
OFF/LOCK position.
Joined May 21, 2004
·
28,308 Posts
That last post works
STEVE
Joined Mar 18, 2015
·
39 Posts
Yeah my manual has a different set of instructions which don't work, but the gas pedal instructions do. Drove me nuts until I looked it up on this forum. I guess they've since updated the manual, but I bought mine in March 2015 and you'd have thought they would have changed it before then...