How to reset maintenance light on 2006 toyota corolla

Undo your battery for a couple of minutes. This worked on the older models. I believe this is the procedure for yours.

Table of Contents Show

Your Answer:
Looking for a Used Corolla in your area?
To reset the 2006 Toyota Corolla maintenance light, please follow these instructions:
1. Turn the ignition to run (one position before starting engine). 2. Ensure odometer reading is shown. Turn ignition off. 3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine). 4. Hold down knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing. 5. Turn the ignition off and then start the engine to verify the indicator has been reset.
How do you reset the maintenance required light on a Toyota Corolla?
How do you reset the maintenance required light on a 2006 Toyota Camry?
What does the maintenance light mean on a 2006 Toyota Corolla?
How do you reset the maintenance light on a 2005 Toyota Corolla?

Turn the ignition key to 'ON' and press the odometer button until the display reads ODO (not Trip A or B).

Turn the ignition key to OFF.

Hold in the same button you used in step 1.

While holding the button in, turn the ignition key to ON.

The ODOMETER will change to:

5 dashes - - - - -

Then 4 dashes - - - -

Then 3 dashes - - -

Then 2 dashes - -

Then 1 dash -

THEN all zeros 0 0 0 0 0

Then back to the correct mileage.

Then the Maintenance Required light should blink and go out.

2007

http://www.ehow.com/how_6400319_reset-co...

http://wiki.answers.com/Q/How_do_you_res...

2005

http://wiki.answers.com/Q/How_do_you_res...

Home
/ Questions
/ Toyota
/ Corolla
/ How do I reset the maintenance required light after changing the oil in the 2006 Corolla?

Your Answer:

Looking for a Used Corolla in your area?

CarGurus has 24,740 nationwide Corolla listings starting at $1,795.

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Tired of ads? Remove them as a Premium Member. Read more

Jul 20

2006 Toyota Corolla

To reset the 2006 Toyota Corolla maintenance light, please follow these instructions:

1. Turn the ignition to run (one position before starting engine). 2. Ensure odometer reading is shown. Turn ignition off. 3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine). 4. Hold down knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing. 5. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the maintenance required light on a Toyota Corolla?

Turn Off Maintenance Light: Toyota Corolla - Trip Reset Button.

Place your key in the ignition, and turn it to the "On" position. ... .

Press and hold the trip reset button. ... .

Once these words display, return the key to the "Off" position..

While holding the trip reset button down, turn the key back to the "On" position..

How do you reset the maintenance required light on a 2006 Toyota Camry?

Quickly, push and hold the odometer button your dashboard, then turn your key to position two. Continue to hold the odometer button for 10 seconds. If done correctly, the maintenance light should flash and you may hear a beeping. That should turn off the maintenance light on your Toyota Camry.

What does the maintenance light mean on a 2006 Toyota Corolla?

The Toyota maintenance light can appear on your dashboard as “MAINT REQD”. It's a light that remains active permanently, letting you know that you need to go for an oil change in a certified auto shop. Changing the oil in your Toyota can improve fuel efficiency and make your vehicle run as smooth as silk.

How do you reset the maintenance light on a 2005 Toyota Corolla?

Turn Off Maintenance Light – Toyota Corolla Turn the key to the “ON” position, but don't start the car. Press and hold the trip reset button near the odometer until “Trip A” appears on the central screen. Turn the key back to “OFF.” While pressing the button to reset the trip, turn the key back to the “ON” position.