How to replace water line in kenmore refrigerator door

Cold, filtered water from your refrigerator—it's delicious, refreshing, and incredibly convenient. So it's incredibly frustrating when your fridge stops dispensing it. Don't worry though, Asurion Experts are certified, trained and have experience with every major home appliance, so they can help. Here's their guide to why water isn't coming out of your refrigerator and how to fix it.

Why is my fridge water dispenser not working?

The first step to fixing any appliance is to figure out what the issue is. If the water dispenser isn't working on your fridge, these are the common causes and how to get things flowing again. If at any point you get stumped or it seems like you need an advanced repair, contact an Asurion Expert for help.

A clogged or dirty water filter

A dirty or clogged water filter means less water can flow through the system. The good news: Replacing it is usually a straightforward process. Check your refrigerator's manual (it's usually available online) for instructions on how to replace your filter, including which replacement you'll need and how often to change it to prevent further issues. A dirty or clogged water filter can also cause a clog in your water supply lines—so after cleaning the filter, be sure to clean the water line.

Nobody needs more chores

Broken appliance? We can fix it fast. Just schedule a repair, and our skilled experts will repair it in days, not weeks.

Schedule a repair

A blocked, kinked, or frozen water line

Water can stop flowing from the fridge dispenser when supply lines become frozen, clogged, or kinked. Some water lines run through the freezer, so if the temperature is set too low, the water line will become frozen. If there is ice in the line, allow it to defrost. Follow the steps in our guide to cleaning your refrigerator water line to help determine if a clog is your issue.

You should also check for kinks or bends in water lines that could slow the flow of water, and make sure there is ample space behind your refrigerator for the lines.

A damaged water inlet valve

The water inlet valve connects your fridge to your home's main water supply. It can become clogged or broken over time. To check the water inlet valve, unplug the refrigerator, turn off the water supply, and remove the rear panel. Check the valve and connected lines for any leaks or damage.

An issue with a water inlet valve can also stem from power not reaching it effectively. If you have electrical skills, you can test the power supply using a multimeter (if not, we recommend you book a repair with an Asurion Expert). With the water line still disconnected and the power still off, locate the valve's solenoid coils. Disconnect the two wires from the terminals located on the coil. Use a multimeter to test the solenoid and see if it is running electricity steadily. If it isn't, it may need to be replaced.

Other causes of a broken refrigerator water dispenser

If there are no issues with the water supply system, you may need to take a look at a few other components. Malfunctions involving a faulty pressure switch, a water dispenser actuator, a refrigerator door switch, or a control board could be among your problems. You can inspect these components visually for damage or shorts or test the circuits with a multimeter. We recommend you reach out to an Asurion appliance repair expert to help you diagnose these problems and repair or replace these components.

One simple protection plan for your home's major appliances

Forget what you know about warranties, Asurion Appliance+ is so much more. Cover all your eligible appliances—no matter where you bought them—and get 24/7/365 troubleshooting support, all for less than $1 per day. Learn more about Asurion Appliance+ coverage and how you can get total peace-of-mind protection.

Jake

Appliance Tech - Admin

• #2

Ok,

You do everything from your front dispenser, remove the old one, pull it up and out, then push the new one down in, there is a conduit channel that runs through the freezer door down and out the freezer hinge.

Just follow these instructions

Here's the water dispenser tubing kit for your model you can order here:
8201537 Dispenser Water Tube Kit

Watch this video:

Now some models don't have those 2 screws to remove the dispenser trim like in that video, If you don't see those 2 screws then look underneath the bottom frame you will see 2 slots, just take a flathead screwdriver and pop that plastic frame off, then you can get good access to it.

Don't worry, I changed lots of these and never even came close to breaking the line half way through the door when pull it out from the front dispenser.

Jake

Jake

Appliance Tech - Admin

• #4

Glad to help, keep us posted.

Jake

Jake

Appliance Tech - Admin